Focusrite Saffire Pro26
24 bit/192 Khz firewire audio-interface van Focusrite. 8 mic inputs inputs, 8 line inputs, 2 line in, Spdif, ADAT, wordclock aansluiting. Midi. 2 xhoofdtelefoonlevel en monitorlevel apart in te stellen inclusief dim en mute. Bus powered. Inclusief een stapel zeer bruikbare DSP effecten
Microphone Inputs
- Frequency Response: 20Hz - 20kHz +/- 0.1 dB
- THD+N: 0.001% (measured at 1kHz with a 20Hz/22kHz bandpass filter)
- Noise: EIN > 120dB (measured at 60dB of gain with 150 Ohm termination (20Hz/22kHz bandpass filter)
Line Inputs
- Frequency Response: 20Hz - 20kHz +/- 0.1dB
- THD+N: <0.001% (measured with 0dBFS input and 22Hz/22kHz bandpass filter)
- Noise: -90dBu (22Hz/22kHz bandpass filter)
Instrument Inputs
- Frequency Response: 20Hz - 20kHz +/- 0.1dB
- THD+N: 0.004% (measured with 0dBu input and 20Hz/22kHz bandpass filter)
- Noise: -87dBu (20Hz/22kHz bandpass filter)
Weight and Dimensions
- 3kg - 35cm x 4.5cm x 23.5cm
Analogue Input Specs
- Mic: 8 x XLR on rear panel
- Mic Gain: +13dB to + 60dB
- Line 1-8: 2 x 1/4” TRS Jack (front panel)
- Line 1-8 Gain: -10dB to +36dB
- Instrument: As above, switched to Instrument (inputs 1 & 2 only)
- Instrument Gain: +13dB to +60dB
Analogue Output Specs
- Line level 8 x 1/4” TRS Jack
- Nominal output level 0dBFS = 16dBu, balanced, +22dBu globally switched with external PSU connected across all outputs
- Frequency Response: 20Hz – 20kHz +/- 0.2dB
- THD+N <0.0010% (-100dB) (measured with 0dBFS input 22Hz/22kHz bandpass filter, un-weighted)
- Software switched hardware DIM –12dB in output pairs 1-2, 3-4, 5-6, 7-8
- Software Digital Volume control for all outputs
- All outputs are useable as monitoring outputs
DIGITAL I/O (Saffire PRO 26 i/o)
- 1 x SPDIF In / Out (RCA phono) on rear panel (24-bit, 192kHz) Output transformer isolated
- 2 x ADAT In / Out (44.1 / 48kHz), 16 channels
- 1 x ADAT In / Out (88.2 / 96kHz), 8 channels S-MUX
- Word clock input on BNC
- Word clock output on BNC
- Clock Sources: Internal clock, Sync to word clock on S/PDIF, Sync to word clock on BNC word clock input, Sync to word clock on ADAT1 or ADAT2 inputs
- A/D Dynamic Range 110dB 'A-weighted' (all inputs)
- D/A Dynamic Range 110dB ‘A-weighted' (all outputs)
- Clock Jitter < 250 pico seconds
- Sample rate 44.1 to 192kHz
DIGITAL I/O (Saffire PRO 10 i/o)
- 1 x SPDIF In / Out (RCA phono) on rear panel (24-bit, 96kHz) Output transformer isolated
- Clock Sources: Internal clock and sync to S/PDIF
- A/D Dynamic Range 110dB 'A-weighted' (all inputs)
- D/A Dynamic Range 110dB ‘A-weighted' (all outputs)
- Clock Jitter < 250 pico seconds
- Sample rate 44.1 to 96kHz
MIDI I/O
- 1 in / 1 out on rear panel
Firewire 400 (1394a)
Power
- Either via Firewire (1394a) or external PSU (included)
Headphone Monitoring
- 2 x 1/4” TRS Jack on front panel (mirrors outputs 5-6 and 7-8)
- High power headphone drivers
!
<<
|
Van €891.-
|